Tel: 0800 0234 119 (UK) / 0044 1443 772 500 (INT) | Fax: 0800 0234 120 (UK) / 0044 1443 775 426 (INT)
Help & Advice
Gently pull the Solenoid Coil Housing upwards until it is clear of the solenoid fixed core centre tube.
Extract the Solenoid Coil by turning it at an angle, then pass it through the front of the Solenoid Coil Housing.
Using an Allen Key, loosen the housing cap securing grub screw, turning anti-clockwise, so that the point clears the cap rim.
Insert the clip extraction tool into the small hole in the C Clip. Pull the clip
out and retain the clip.
Contact Red Dragon for further information, installation
data, and recommended spares.
1. C Clip Tool KM3062
2. Screwdriver
3. Fixed Core Tool KM/2621
4. Core Lever Pin
5. Allen Key 2mm
6. 16mm Spanner
Unscrew the Solenoid Coil Housing Cap anti-clockwise taking care of the security chain, and place to one side.
Replace the Solenoid Coil and reassemble in reverse order. Apply the electrical power and check.
image
Loosen the two power cable on the solenoid coil terminal board, noting any colour codes. Depending on the valve model, usncrew the internal earth screw.
image
